Page 1 of 1
Thread size wanted
Posted: Sat Aug 06, 2011 12:59 pm
by roymck
Does anybody know the thread size in the inlet manifold for the temp sender please? Thanks Roy
Posted: Sat Aug 06, 2011 1:35 pm
by michael-king
Roy,
The stock setup has the sender in the T in the heater/cooling system hoses, so i assume you are talking about a 4BBl manifold, what type of manifold are you using?
Posted: Sat Aug 06, 2011 2:25 pm
by gtsmrt
Hi Roy,
I'm fairly sure the thread is 3/8", but a lot of the aftermarket manifolds have 1/2" threads. I had to use a reducer on my Weiand manifold (I think Edelbrock are th same).
Regards, Robin.
Posted: Wed Aug 10, 2011 11:26 am
by roymck
Hi Thanks for the info , its an Edelbrock 4 bbl ... Roy